P-BULB WEATHERSEAL, BOTTOM - 280/288/180/381/390 SERIES

It was shipped wrapped up and flat. Therefore, once it was install it stayed flat instead of becoming a bulb. Didn’t seal at all.

Used this weather seal on both my 8 foot and 16 foot door. I lubed the P portion of the seal with dish washing liquid and slid it on the bottom of the track of the 8 foot door and had it installed in 25 min. The 16 foot door was a bear . It took me about 1 1/2 hours of pulling but I got it on. A second person helping on the larger door would have helped.Cleaning the rust and debris from the bottom track is a must. At the end I used a heat gun on the seal and when rubber seal was heated pushed from the bottom center up to open the seal up to a round shape. Looks and works great.

Exactly what I need to replace the bottom seal on my Overhead garage doors. Yes, it is delivered flat because it's rolled up for shipping. I used a heat gun to restore the seal to its original, round shape.

The product quality was good but it was very difficult to install. It did not slide easily into the old bracket. Had to use a lot of grease and pull like hell.

I only needed 55 ft but HAD to order 60. Shipping cost of $28.00 Too much and you should offer alternative delivery by a cheaper method. I was in no hurry for the item. Got the job done but feel ripped of by this transaction and will consider this if I again need something from Overhead Doors.

great product, fairly easy to install, very quick shipping. I told by my local deal this produchad been discontinued, so I ordered from the "Overhead Door"web site with no problems.

The weatherseal installed with expected level of difficulty, fit well, and formed bulb shape as soon as door was lowered. No daylight is visible below closed door.

I purchased two 10 ft. sections of P-Bulb weather seal from the Overhead Door Company as it wasn’t available locally. Shipping was expensive, but both seals were exact replacements although somewhat thinner. Replacing was easy. Stopped the door approximately eye level, uncrimped both ends and pulled the old seal out. Cleaned track with a brush, applied a small amount of dish washing soap to P part of seal and with the help of my wife, slid the new seal through track and crimped track ends. Very easy and quick. Did two 8ft. doors and next will be the 16ft. door. Haven’t done it yet, but I don’t see a problem with the additional length. Be careful who you buy from on line. Some of the P-Bulb weather seals are not P but D and the D-Bulb is inferior and drops out of the track. I found out the hard way. Overhead Door Company sells exactly what they advertise. Thank you Overhead Door Company. Getting ready to place another order.
P.S. Mine came out of the box flat too, but after installation, opening and closing my garage doors, they maintain a bulb shape and flatten out when door seal seats to floor.

I decided to go with the original replacement seal from Overhead believing it would be of better quality or equal to what I already had. The seal I removed was thicker material and held it's shape for 18 years. This new one is thinner and came out of the box flat. It does not compare to the original seal. Wish I had gone with less expensive alternatives.

After being told in town that this part is no longer available and that I needed to buy an entire new channel I decided to look online. Thank gooddness I found OHD parts online. They shipped exactly what I needed very quickly. Parts fit perfectly and I'm back in service. Thank you so much.

Online description and fitment was perfect

Very easy to install and seals good.