GARAGE DOOR OPENER LED LIGHT BULB (OHD)

The Overhead Door LED light bulb has been specifically designed and tested for garage door openers. This LED bulbs avoids the remote interference that standard LED and CFL bulbs produce. The Overhead Door LED light bulb features: Remote radio...

RELEASE CORD

Emergency release cord to be used with any manufacturer and model residential garage door opener. Length: 45"   Part Numbers: 21123F, 21123C, 21123, 21123B,

SAFETY BEAM WIRE

Safety beam (photocell) kit wire. Can also be used to wire push buttons and wall consoles. Approximately 90ft.   Part Number: 20303, 20303A, 35265, 35265B.S

RELEASE KNOB

Emergency release knob to be used with all manufacturer and model residential garage door openers.   Part Numbers: 37107CS, 37107, 21122A, 21122

GARAGE DOOR OPENER LED LIGHT BULB (GENIE)

The Genie LED light bulb has been specifically designed and tested for garage door openers. This LED bulbs avoids the remote interference that standard LED and CFL bulbs produce. The Genie LED light bulb features: Remote radio frequency friendly - no...

BELL WIRE (25FT)

Bell wire to be used for wiring the safety beams (photocells). Can also be used to wire push buttons and wall consoles. Approximately 25ft.   Part Number: 20303, 20303A, 35265, 35265AS, 35265A, 35265A.S

WIRE CLIP - OVERDRIVE

Wire clip for the Overhead Door Overdrive (model #990) series garage door opener.   Part Numbers: 33905A, 33905A.S, 33950

CABLE KEEPER (WALL MOUNT)

Cable Keeper kit for the Overhead Door Infinity 2000 #9020 & #9120 and Genie #6070 & #6170 Wall Mount garage door openers   Part Numbers: 39794, 39794R, 39794R.S

GARAGE DOOR OPENER SURGE PROTECTOR

The Genie Garage Door Opener Surge Protector is designed to protect a garage door opener from power surges that can cause damage to circuit boards, photocells and other electronic components. The surge protector cuts power to the connected equipment in...

MOUNTING PARTS PACK (ORANGE BAG) - 39010RS

Garage door opener mounting hardware pack. This mounting parts pack was labeled as the orange bag in the original Genie garage door opener installation instructions that was included with multiple Chain Drive, and Belt Drive models (listed below)...

WIRE CLIP - SCREWDRIVE

Wire clip for the Overhead Door Python series garage door opener.   Part Numbers: 24222A, 24222

RAIL SUPPORT KIT

Center rail support kit for the Overhead Door Destiny and Odyssey series garage door openers. To be used with opener rails for garage doors exceeding 8ft tall. Includes (2) rail brackets and all fastners.   Parts Numbers: 37216, 37216RS, 37216R.S,...

MOUNTING STRAP

Mounting strap to be used with the Overhead Door Odyssey,Destiny, Legacy 850 and Standard Drive 650 series garage door openers.   Part Numbers: 36728A, 36728

DISC, CLUTCH - STATIONARY

Clutch disc - stationary Part Numbers: 75194, 75194.0000.S, 75194.0001, 75194.0001.S

MOUNTING BRACKET (ODYSSEY/DESTINY)

Mounting bracket to be used with the Overhead Door Odyssey,Destiny, Legacy 850 and Standard Drive 650 series garage door openers.   Part Numbers: 36987A, 36987

POWER EXTENSION KIT - WALL MOUNT (OHD)

The Overhead Door power extension kit (alternate power kit) is compatible with the Overhead Door Wall Mount garage door opener (model #9120H, 9120HB, 9020H and 9020HB). The kit is perfect for applications without a 115 VAC outlet within 5ft of the...

LABEL

OPTO ENCODER WHEEL - 38252A.S

This replacement opto-wheel is used on the Overhead Door and Genie model garage door openers listed below. This opt-wheel normally needs replaced if your garage door opener is short traveling in both directions (open and close), in the excess of 6...

STILE, END - 1 3/8" X 21" LEFT HAND, WHITE (194, 195, 197, 5740 SERIES)

End stile for the Overhead Door Thermacore 5740 series garage door (also compatible with model #194, 194 and 197). Color: white, Section thickness: 1 3/8", Section Height: 21". Section location: Left

STILE, END - 1 3/8" X 21" RIGHT HAND, WHITE (194, 195, 197, 5740 SERIES)

End stile for the Overhead Door Thermacore 5740 series garage door (also compatible with model #194, 194 and 197). Color: white, Section thickness: 1 3/8", Section Height: 21". Section location: right side

HARDWARE KIT (WALL MOUNT)

Miscellaneous hardware kit for the Overhead Door Infinity 2000 #9020 & 9120 and Genie #6070 & #6170 Wall Mount garage door openers.  Includes: bolt, washer, screw, washer and grounding screw   Part Numbers: 41375, 41375R, 41375R.S

HARDWARE KIT, PARTS (WALL MOUNT)

Miscellaneous parts hardware kit for the Overhead Door Infinity 2000 #9020 & #9120 and Genie #6070 & #6170 Wall Mount garage door opener.   Parts Number: 39946R, 39946, 39946R.S

POWER EXTENSION KIT - WALL MOUNT (GENIE)

The Genie power extension kit (alternate power kit) is compatible with the Genie Wall Mount garage door opener (model #6170H, 6170B, 6070H and 6070B). The kit is perfect for applications without a 115 VAC outlet within 5ft of the opener at the time of...